Results 1 to 7 of 7
Thread: diy plywood tank questions
08-27-2011, 01:12 AM #1
diy plywood tank questions
i have been doing a lot of research and i am going to build a 6ft x 2ft x 25ft. tank. From what i have found out i need a front viewing window for 3\4 inch thick. From what i found out is one of the main factors in glass thickness is the unsupported area. So my question is if i put a center brace could i use thinner glass for the front?
08-27-2011, 08:16 AM #2
it's going to depend on the height of the tank and the size of the window
08-30-2011, 04:12 PM #3
25'??? Wow, unless your doing allot of segments? I wouldn't go any thinner than 3/4". That's just my 2 cents... :)"The greatness of a nation and it's moral progress may be judged by the way it's animals are treated", Gandhi
Shark fin soup... A bowl of Travesty I will NEVER stomach".
08-30-2011, 08:18 PM #4
08-30-2011, 08:48 PM #5
did you mean to put a decimal place in there?6x2x2.5 maybe? Or are you seriously building a 4500 gallon tank?300 gallon mega tank: build in progress
75 gallon community tank: tetras, danios, corys, platies, otos, pearl gouramis, bristlenose pleco, assassin snails, red cherry shrimp, bamboo shrimp
70 gallon growout tank: clown loaches, sailfin pleco
60 gallon goldfish tank: fancy goldfish
29 gallon frog tank: 1 bullfrog
10 gallon and 5.5 gallon betta tanks: 1 male betta each, sometimes snails
09-09-2011, 11:22 PM #6
ya it should be 6ft x 2ft x 2ft sorry
09-10-2011, 07:30 AM #7
Here, try this link out for your measurements.
http://www.theaquatools.com/building-your-aquariumNo warrenties expressed or implied; opinions subject to change without notice :P
If I put instant coffee in a microwave, will I go back in time?
NEVER be afraid to make a complete fool of yourself. You may be surprised at how much fun you could have.