Results 1 to 7 of 7
Thread: Debris in new tank
-
06-18-2011, 02:54 PM #1
Junior Member
Guppy
- Join Date
- Jun 2010
- Location
- Virginia
- Posts
- 18
Debris in new tank
I have just set up a new 10g tank for my DAFs. Substrate, gravel, plants, driftwood, rocks. I am using 2 Whisper filters (for 5g tanks, long story) and although the water is clearing up nicely, there is a lot of debris on the wood, rocks and substrate/gravel. Should I agitate the water to stir up and filter out the debris? All the "stuff" is probably from the plantings which settled before the filters could do their job. Suggestions?
-
06-18-2011, 06:14 PM #2
You could use a better filter to grab some of that stuff floating around. I use a 20 Whisper on my 5 gallon and that hardly moves the water at all.
Cycling With Fish?•• The Fishless Cycle••
Goldfish Growth Expectancy••
The single biggest problem with communication is the illusion that it has taken place. "George Bernard Shaw"
-
06-18-2011, 07:29 PM #3
Dont sweat it. Thats just something that happens when the tank is new or after you move stuff around or plant. It will settle off by itself with time.
-
06-19-2011, 12:03 AM #4
I have a lot of plant debris too. Thanks for posting everyone. You're helping me too.
The master of all things Corydora
10 gallon that will soon have corys
frequent aquarium forum searcher
and cookie monster fan
-
06-19-2011, 02:48 PM #5
Junior Member
Guppy
- Join Date
- Jun 2010
- Location
- Virginia
- Posts
- 18
Lighting
Hey! Thank you for responding to my aquarium debris questions. I might look into a better filter as suggested. Now another question. After tons of research, I have settled on lighting that consists of a T8 fluorescent bulb, 15W, 6500k, full spectrum. (I already had the hood on my old tank and it only holds the T8 bulbs.) While I set up the new tank, I used a desk lamp with a compact fluorescent bulb, 27 watts, 6500k for temporary lighting which looks much brighter. I understand the wattage is different, but shouldn't the brightness be the same at 6500k?
-
06-19-2011, 03:10 PM #6
The k rate gives the info about the tone of the light lowere is a more yellow red higher is a whiter lights. The wattage is its output and the cf bulb would appear brighter then the t8 even if the w was the same.
-
06-19-2011, 05:30 PM #7
Junior Member
Guppy
- Join Date
- Jun 2010
- Location
- Virginia
- Posts
- 18
Thanks Smaug!
I think I better understand the Kelvin rating vs the wattage. I can't say that I am not still a little confused however. What would you use in a planted, 10 gallon tank? I just have the two little DAFs and plan to get a couple of tetras just for color. This tank is primarily for frogs and plants!





Reply With Quote

Welcome to the New AC. Please be patient while I try to resolve all the bugs this update is sure to bring. In the end it will all be worth it!!
Replacing...
Today, 12:16 PM in General Aquarium Forum