Results 1 to 10 of 13
Thread: Siphoning Help
08-17-2013, 10:53 PM #1
At the risk of sounding like a doofus and this being a DUH question, I need some help. I've always been a proud member of the bucket brigade when doing water changes but recently I've just grown tired of the many trips it takes with a one gallon pitcher and have upgraded my gravel vacuum to a fairly large gravel siphon with a much longer hose. Now here is the rub: I can successfully vacuum the gravel out and just put the hose outside the front door in order for the water to run off into the grass. That so far has been no issue. The issue is when I try to add water to the tank. The tank is located in the living room which places it just barely within reach of the kitchen sink. I have an old faucet head and the adapter piece simply won't work on it. Instead of that, I thought I'd just fill the sink up with the water I needed and reverse siphon it into the tank. I cannot for the life of me get the suction started from the sink to the tank. It just won't work. As I said, this may be a very obvious and silly question, especially for someone that isn't new to the world of tank maintenance, but I'm asking anyway because I can't seem to figure it out.
36g Bowfront Journal: http://www.aquaticcommunity.com/aqua...d.php?t=116509
08-17-2013, 11:20 PM #2
Is your kitchen sink at the same height or lower than the tank? Water wants to travel to the lowest point. If you have two containers with a water-filled tube between them, the water will move from the container with the higher water level to the one with the lower.
08-17-2013, 11:21 PM #3
For a reverse siphon to work, the sink needs to be higher than tank.
Can you get a longer hose and use some other faucet? Bathroom, laundry tub...you should be able to change out the fitting on the kitchen faucet to one that will take the adaptor...
08-17-2013, 11:41 PM #4
030 g FW planted:corys, ABNP, blue angel, harleys, zebra danios, rummies, mystery & nerite snails
15 g FW planted:crown tail betta, neons, pygmy cory, clown pleco, mystery & nerite snails
90 g FW planted:congos, rainbows, roseline sharks, swordtails, krib pair, ABNP, peppered cories, mystery snails
90 Gal Journal: http://bit.ly/1vC7gVX
fishless cycling: http://bit.ly/1DARf3T
fish in cycling: http://bit.ly/1ILvcfp
08-17-2013, 11:56 PM #5
If all else fails y0u can fill the sink, dechl0rinate the water and buy a cheap f0untain pump t0 h00k the h0se t0 and pump it int0 the tank.When in d0ubt read it until it makes sense, then read it again!
08-17-2013, 11:59 PM #6
+1 to sheamurai, that's what I did and I got a nice adaptor that I have had no problems with. Also, my sink is slightly below my tank (we are talking only a few inches though) but the reverse syphon still works for me. Good luck! Kepp us informed :)Tanks: 30 gal community and 10 gal shrimp/community
08-18-2013, 03:12 AM #7
Cheap fountain pump I think will take a long time as I don't think it will very powerful. Taking vacuum to hardware store and see what they can rig up for you is what I did.25 Gal - Tropical
Custom made Wet/Dry/Sump Filter System, AquaClear 20 Powerhead, RenaCal Excel 300 Heater, artificial plants
Fish - 7 Blackskirt Tetras, German Blue Ram, Bulldog Pleco, Assassin snail.
"Plans go wrong for lack of advice; many advisers bring success." King Solomon.
Pictures of my 10 Gal Sump Filtration project
08-18-2013, 03:39 AM #8
Lots of good solutions to the op's problem. In the meantime, though, while the op has time to get added gear or adapters, a temporary, completely low-tech solution is to place a bucket on top of the counter next to the kitchen sink, and fill THAT with dechlor water instead of filling the sink itself. Since the bucket sits on top of the counter, the top of the bucket will be higher than the sink by a foot or more, and perhaps this change in height is enough to get the siphon to work.
08-18-2013, 05:00 AM #9
Personally, if I'm filling a bucket with water anyway, I'd rather just walk it over and dump it in than wait for a siphon to empty it. That being said, the bucket on the counter would be much less straining on the back. I have heard of others making their own pythons using a waterbed draining kit.
Then you just fit your hose to that, hook it to the sink and the pressure of the faucet will push the water up the hose and into the tank. These are designed to work with an actual garden hose though, so you still may have to buy additional fittings at the hardware store. It just has the convenience of the T-shape and the valve at the sink that you can use to change the flow of the water in or out of the tank.~Manna
10 gallon live planted aquarium with 6 neons
90 gallon fw community in progress
08-18-2013, 05:44 AM #10