Ammonia Level to Dose any Tank
I have referenced this article (and the foot noted research paper) a few times, and after mommie1 has reminded me that I need to post the source (and send her a copy after forgetting her first request - sorry - here it is.) I will add that this is a new thread since the orginal thread where I was asked to supply the article is now closed (?); hence creating this new thread.
So, here is the article and it is a bit long but well worth reading. I hope it ends some running issues; regardless of this paper's ideas/conclusions, adding 1 ppm, or 2 pp, or even 6 ppm will get the ammonia cycle to run. The issue is that this may impact the cycle that converts nitrite into nitrate but than again, people's tanks differ, as may their results.
Here is the site:
Knowledge is fun(damental)
A 75 gal with eight Discus, fake plants, and a lot of wood also with sand substrate. Clean up crew is down to just two Sterba's Corys. Filters: continuous new water flow; canister w/UV, in-tank algae scrubber!! Finally, junked the nitrate removal unit from hell.
For Fishless cycling:http://www.aquaticcommunity.com/aqua...ead.php?t=5640
I completely missed this thread yesterday. Thank you for posting the information. The article is not peer reviewed as you stated but when I get a chance between semesters I will definitely look into its sources. I have no doubt that adding too much ammonia is detrimental to the cycle process, but I don't believe it is too much if our testers can still register the amount. It's good to have something fun to study between my formal studies...
If it's called tourist season why can't I shoot them?
Everything happens for a reason. Sometimes that reason is you are stupid and make bad decisions.
I think my fish is adjusting well to the four gallon, He's laying on his side attempting to go to sleep on the bottom of the gravel.
A moderator on a fish forum should be able to identify an oscar... Don't you think?
Dear naps, sorry I hated you so much when I was a child... Love me