Results 1 to 3 of 3
Thread: DIY Tank Divider
04-21-2012, 06:31 AM #1
DIY Tank Divider
I need a divider for my 5-gallon tank so I can split it between Rainbow and Comet, and get Comet out of that tiny pickle jar. Unfortunately, the lfs only carries dividers for tanks 10 gallons and up, and cannot order one in a smaller size (I asked). So, please, tell me how to make a divider for this tank.
Please realize that I have never done DIY ANYTHING when it comes to my aquariums. Complicated instructions will go right over my head. Please help me, and please explain things clearly.
The probability of being watched is directly proportional to the stupidity of the act
04-21-2012, 10:26 AM #2
Just type it into google and there are alot of easy, picture step by steps out there.2.5 Gal- Frank, Male Betta, HM- Low Tech Planted Tank
5.5 Gal- Fancy Male Guppies- Maintained for the Dorm Room
360 Gal- Pond- An Goldfish Adventure!
04-21-2012, 11:48 AM #3
Get one of those thick plastic sheeted binders that have the plastic rib that the paper slides into. You will need two of those ribs or one cut in half, depending on the height of the tank
Silicone/supegrlue the two pieces of rib to the inside of the tank facing each other. Then simply slide the plastic sheet into them. Personally I would cut slits in the sheet to promote proper water flow if both sides will not be filtered.